Drain Line Replacement
312805A 23
Drain Line Replacement
Removal
1. Cut drain line (49) from barbed fitting (51).
2. Unscrew barbed fitting from filter manifold (43).
Installation
1. Screw barbed fitting (51) into filter manifold (43).
2. Push drain line (49) onto barbed fitting.
To reuse existing barbed fitting (51) and drain line
(49), cut and remove remaining drain line material
from end of barbed fitting.
To make drain line more pliable and easier to install
over barbed fitting, heat end of drain line (49) with a
hair dryer or place end in hot water a few seconds.
51
49
ti9156a
43
To Next Page
Loading...
