Pressure Control Assembly Replacement
312805A 21
Installation
1. Inspect pressure control before installation to verify
o-ring is installed.
2. Align pressure control wire cap (21) on fluid mani-
fold so opening faces toward motor.
3. Apply loctite to pressure control knob (B) threads.
4. Screw pressure control threads (B) into manifold
and torque to 150 in-lb (17.0 N.m).
5. Tuck wires into pressure control wire cap (21) and
route wires toward cap opening. Feed wires through
housing hole (K).
6. Insert bushing (23) in hole (K).
7. Connect pressure switch connector (A) to control
board (18).
8. Install shroud (12) with screw (13). Install front cover
(32) with two screws (11). (see illustration, page 14).
9. Install the following on 210
ES Hi-Boy models:
a. Install toolbox (3) with two screws (5).
b. Install kick stand (66).
K
o-ring
A
23
18
21
ti9129a
B
Caution
Be careful when tightening pressure control knob that
wires are not pinched between pressure control and
fluid manifold.
To Next Page
Loading...
