Instructions–Parts List
SEVERE-DUTY, UHMWPE/PTFE OR PTFE PACKED
Stainless Steel Pumps
Used to transfer or dispense low viscosity sealants and adhesives.
For professional use only.
UHMWPE/PTFE PACKED PUMPS
Model No. 224342, Series A
10:1 Ratio Presidentr Pump
1800 psi (13 MPa, 125 bar) Maximum Fluid Working Pressure
180 psi (1.3 MPa, 12.5 bar) Maximum Air Input Pressure
Model No. 224343, Series A
5:1 Ratio Monarkr Pump
600 psi (4.2 MPa, 42 bar) Maximum Fluid Working Pressure
120 psi (0.8 MPa, 8.4 bar) Maximum Air Input Pressure
UHMWPE/PTFE PACKED PUMPS
Model No. 261630, Series A
PTFE PACKED PUMPS
Model No. 247147, Series A
Model No. 902147, Series A
5:1 Ratio Monarkr Pump
600 psi (4.2 MPa, 42 bar) Maximum Fluid Working Pressure
120 psi (0.8 MPa, 8.4 bar) Maximum Air Input Pressure
Severe-Duty Displacement Pumps have an abrasion-resistant
displacement rod and cylinder. Refer to Technical Data on pages
22–23 for Wetted Parts information.
308116S
EN
0195
Model 224342 Shown
Important Safety Instructions
Read all warnings and instructions in this manual.
Save these instructions.
To Next Page
Need help?
General
