Graco FieldLazer S200 - Startup and Initial Operation

Pressure Control
12 311019L
Pressure Control
On/Off Switch
Removal
1. Relieve pressure, page 5.
2. FIG. 14. Remove two screws (108) and open cover (62a).
3. Disconnect ON/OFF switch connector from PC board.
4. Press in on two retaining tabs on each side of ON/OFF
switch (62d) and remove switch from cover.
Installation
1. Install new ON/OFF switch (62d) so tabs of switch snap
into place on inside of cover.
2. Connect ON/OFF switch connector (B) to PC board.
3. Close cover (62a) and secure with two screws (108).
FIG. 14
ti6389a
62d
62c
62b
62a
62e
62g
62f
155
62b
ground
green/yellow
pink
(from engine)
clutch (-)
clutch (+)
(black)
(red)
108
66