To Next PageTo Next PageWhy is the ON/OFF switch constantly illuminated on my Graco FinishPro GX19 Paint Sprayer?
If the ON/OFF switch on your Graco Paint Sprayer is constantly illuminated and does not turn off, replace the control board, as it may be damaged.
How to fix a Graco Paint Sprayer with poor spray pattern?
If your Graco Paint Sprayer pump is primed, but you cannot achieve a good spray pattern, try the following: Clear any spray tip clog. Ensure the reversible spray tip is in the SPRAY position. Strain the paint to remove debris. Adjust the pressure by aligning the pressure control knob setting indicator to the desired spray setting. Clean or replace the InstaClean fluid filter and/or the gun fluid filter. If the spray tip is too large or worn, replace it. Replace the spray tip gasket and seal if they are worn or missing. Ensure the inlet strainer is clean and the suction tube is immersed in paint. Charge the battery or reduce the tip size if the battery has insufficient charge. Also, check if the inlet pump valve or outlet pump valve is worn or clogged with debris. If the material is too thi...
General| Type | Airless Paint Sprayer |
|---|---|
| Max Pressure | 3000 PSI |
| Hose Length | 50 ft |
| Power Source | Electric |
| Horsepower | 0.625 HP |
| Warranty | 1 year |
| Motor Type | DC |
| Nozzle/Tip Size | 0.015 - 0.019 inches |
Covers fire, injection, misuse, toxic fluid, and PPE hazards.
Procedure to flush out factory test material before initial use.
Guide for correctly installing spray tips and guards to prevent leaks.
Procedures for pump repair, removal, and installation.
Solutions for problems related to motor function and power supply.
Troubleshooting steps for pump priming and pressure building problems.
