Startup
16 3A4967C
Startup
TurboControl allows for performance
adjustment of the sprayer. To reduce
over-spray, always start at lowest setting and
increase to the minimum setting required to
provide the desired finish.
1. Turn TurboControl to lowest setting.
2. Turn ON/OFF switch to ON position.
NOTE: ProContractor and ProComp models
in SmartStart setting will automatically turn
off when not actively spraying. Sprayer will
start upon re-triggering of HVLP Edge II Plus
gun. Turn switch to ON position if SmartStart
is not desired. In ON mode, unit will still
shutdown after 3 minutes of non-use.
Sprayer will start upon re-triggering of gun.
NOTE: For SmartStart to function, use
components provided with sprayer and Edge
II Plus gun. For replacement parts, see pages
32-37.
If using FlexLiner System:
3. Point gun into a waste area. Evacuate air
from FlexLiner System by holding gun
vertically and pull trigger open until a
continuous spray pattern is observed.
NOTE: Tilt gun back and forth to help in
evacuation of air.
If using remote cup with ProComp Model:
4. Turn pressure regulator to lowest
setting.
5. Turn compressor ON/OFF switch to ON
position.
NOTE: If experiencing low remote cup
pressure, disconnect clear air hose from
compressor outlet (see step 2, page 15) and
allow compressor to run for 10 seconds.
Reconnect air hose.
To Next Page
Loading...
