Troubleshooting
8 311283J
The sprayer overheats Paint buildup on hydraulic compo-
nents
Clean
Oil level is low Fill with oil.
Spitting from gun Air in fluid pump or hose Check for loose connections on
siphon assembly, tighten, then rep-
rime pump.
Loose intake suction Tighten.
Fluid supply is low or empty Refill supply container.
Excessive hydraulic pump noise Low hydraulic fluid level Turn sprayer OFF. Add fluid*.
*Check hydraulic fluid level often. Do not allow it to become too low. Use only Graco approved hydraulic fluid, page
6.
PROBLEM CAUSE SOLUTION
To Next Page
Loading...
Need help?
General
