Trigger Sensor Adjustment
311020Y 19
Trigger Sensor Adjustment
Refer to Troubleshooting for trigger sensor adjust-
ment, and see Operation manual.
Distance Sensor Adjustment
Gear Alignment
1. Relieve pressure, page 7.
2. Fig. 14. Remove dust cap (142) from wheel.
Remove nut (127).
3. Remove wheel (120) from LineLazer.
4. Align gear (67) with sensor.
a. Pull gear out from wheel with gear puller.
b. Push gear in toward wheel with mallet.
5. Install wheel (120) on LineLazer.
6. Install nut (127) until tight, then back off 1/4 turn.
Install dust cap (142) on wheel.
Sensor Height Adjustment
1. Remove wheel (120) from LineLazer.
2. Remove distance sensor (66).
3. Adjust sensor assembly height with two 17 mm nuts
of sensor so bottom surface of sensor is 0.638 +/-
0.020 from bottom surface of shield. Torque to 8 +/-
2 in-lb.
4. Reassemble distance sensor (66) and wheel (82).
.638 in.
ti6400a
120
66
67
120142 127
66
Fig. 14
Frame
Axle
Inside of tire
Distance Sensor Detail
Distance
Sensor
Tire
Gear
To Next Page
Loading...
