18 Application Methods
Radius Stall Layout: Stall Calculator
Measure outer perimeter distance
STALL CALCULATOR
1. Move the striper to the START point of the stalls (18 ft from the inner curb in this example) and line up the
LazerGuide 1700 Start/Stop Laser with the START point.
2. Go to the STALL CALCULATOR screen on the LiveLook display and then press the GUN TRIGGER CONTROL
button to start measuring. Move the striper toward the FINISH point while following the reference line created
earlier (18 ft from the inner curb in this example) with the LazerGuide 1700 Start/Stop Laser.
3. Once you reach the FINISH point press the GUN TRIGGER CONTROL button to stop measuring. NOTE: The
LiveLook display is measuring in both the forward and backwards direction so if you go past the FINISH
reference dot, you can back up the striper before pressing the GUN TRIGGER CONTROL button to subtract
from the measurement.
4. Use the UP/DOWN arrows to adjust the number of stalls to match the number of stalls you selected when
measuring the inner curb radius (16 stalls in this example). The stall width will be certainly be different than stall
width at the curb but don't worry about that - you just need to match the same number of stalls (in this example
the total distance measured was 162.24 ft and the stall width is 10.14 ft). NOTE: The LiveLook display
automatically transfers the calculated STALL SIZE from the STALL CALCULATOR to the LAYOUT MODE
screen.
To Next Page
Loading...
