Application Methods 5
Measure Mode
Used for measuring and marking specific distances
MEASURE MODE
1. Go to the MEASURE MODE screen on the LiveLook display.
2. Put the LazerGuide 1700 Start/Stop Laser on your START point and press the GUN TRIGGER CONTROL
button.
3. Move the striper in a straight line to the FINISH point and press the GUN TRIGGER CONTROL button when the
LazerGuide 1700 Start/Stop Laser is directly over the FINISH point.
At any time while in MEASURE MODE, if an Auto gun is set to active, momentarily hold down GUN TRIGGER
CONTROL to apply a dot. Holding down GUN TRIGGER CONTROL will produce continuous dotted line with 1 foot
dot spacing when moving, used for pre-marking.
NOTE: The striper measures moving forward or reverse.
To Next Page
Loading...
