Application Methods 3
LineLazer V Auto-Layout System
GUN SETUP
For parking lot layout applications, it is recommended that GUN 1 is placed on the right side of the striper and GUN 2
is placed on the left side. It is also important that the guns are placed straight across from one another slightly in front
of the front tire.
STALL CALCULATOR OFFSET
1. Back the striper up to the curb or START reference dot near the curb, then measure the distance from the curb or
START reference dot to the LazerGuide 1700 Start/Stop Laser under your spray gun.
2. In the STALL CALCULATOR screen, input this value as the offset (x) value by using . Store this value
by holding for 2 seconds so you can use this for your future layout jobs.
To Next Page
Loading...
