Start Up
3A4416A 17
5. Perform a power flush. See Cleanup
with Power Flush Adapter, page 23.
Inspect for leaks. If leaks occur, perform
Pressure Relief Procedure, page 13, then
tighten all fittings and repeat Start Up. If there
are no leaks continue with the next step.
Fill Pump (Prime Pump)
1. Move suction tube to paint pail and
submerge suction tube in paint.
2. Turn ON/OFF switch to ON position.
3. Wait to see paint coming out of drain
tube.
4. Turn ON/OFF switch to OFF position.
NOTE: If paint does NOT flow up the suction
tube and out the drain tube, follow the Flush
Storage Fluid, steps 1 - 5, in this section.
High-pressure spray is able to inject toxins
into the body and cause serious bodily
injury. Do not stop leaks with hand or rag.
To Next Page
Loading...
Need help?
General
