Cleanup
22 3A4416A
Cleanup
Cleaning the sprayer after each use results in
a trouble free start up the next time the
sprayer is used.
Cleaning from a Pail
• For short term shutdown periods (over-
night to two days) refer to Short Term
Storage, page 27.
• See Cleaning Fluid Compatibility,
page 30 for information on flush-
ing/cleaning fluids and Static Ground-
ing Instructions (Oil-Based
materials), page 30.
1. Perform Pressure Relief Procedure,
page 13.
2. Remove spray tip and tip guard assem-
bly from gun and place in waste pail.
3. Lift suction tube and drain tube from
paint pail. Let paint drain into the pail.
4. Separate drain tube (smaller) from suc-
tion tube (larger).
5. Place empty waste and flushing fluid
pails side by side.
6. Place suction tube in flushing fluid. Use
water for water based paint and mineral
spirits or compatible oil-based flushing
solvent for oil-based paint. Place drain
tube in waste pail.
7. Turn pressure control knob to the
Prime/Clean setting.
8. Turn Prime/Spray valve down to
PRIME position.
t
2
ti27135a
To Next Page
Loading...
Need help?
General
