Startup
26 309812D
2. Set temperatures
WARNING
This equipment is used with heated fluid, which can
cause equipment surfaces to become very hot. To
avoid severe burns:
• Do not touch hot fluid or equipment.
• Allow equipment to cool completely before touch-
ing it.
• Wear gloves if fluid temperature exceeds 110°F
(43°C).
a. Turn main power ON .
b. Press or to change tem-
perature scale.
c. Press .
d. To set heat zone target tempera-
ture, press or until display
shows desired temperature. Repeat for
and zones.
heat zone target cannot be set higher than
or heat zone targets.
°
F
°
C
A
B
A
B
For zone only, if FTS is disconnected at
startup, display will show hose current (0A). See
step h, page 27.
e. Press to display actual tempera-
tures.
WARNING
Read warnings, page 8. Do not turn on hose heat
without fluid in hoses.
f. Turn on heat zone by pressing
. Preheat hose (15-60 min). Indi-
cator will flash very slowly when fluid
reaches target temperature. Display
shows actual fluid temperature in hose
near FTS.
WARNING
Read warnings, page 8. Thermal expansion can
cause overpressurization, resulting in equipment rup-
ture and serious injury, including fluid injection. Do not
pressurize system when preheating hose.
g. Turn on and heat zones
by pressing for each zone.
B
To Next Page
Loading...
Need help?
General
