Shutdown and Cleanup
309585A 11
Shutdown and Cleanup
Texture Spraying (6-8 gallon Material
Hopper)
When you have finished spraying:
1. Open gun air valve.
2. Turn hopper gun/spray gun
selection switch to SPRAY
GUN.
3. Turn power switch ON.
4. Close gun air valve.
5. Trigger gun into bucket until most of texture mix is
pumped out.
6. Fill material hopper with 2-4 gallons of clean water.
7. Spray inside material
hopper to circulate water
through gun and hose.
While circulating water,
use gun to clean material
hopper.
8. Partially open gun air
valve to use air to
achieve better cleaning
results.
9. Spray water into a waste bucket to empty material
hopper.
10. Turn power switch OFF.
11. Open gun air valve. Relieve Pressure, page 5.
Keep pump and hose clean when switching between simulated acoustic, knockdown and orange peel
applications. A dirty pump can release particles of texture into the finish.
CAUTION
• Turn off sprayer if you are going to stop spraying for 5 minutes or longer.
• Before removing material hose be sure pressure is relieved and material is not in hose.
• To keep unit in good operating condition, always clean it thoroughly and prepare it properly for storage.
WARNING
page 2, 5.
ti2448a
ti2456
ti2446
ti2453
A soft brush can be used to loosen dried on
material.
CAUTION
If water freezes in unit damage may occur. In cold
weather store system where it will not freeze.
TI2461
To Next Page
Loading...
