14 3A9322B
e. Verify spring (33a) is on the trigger,
then install the trigger lock (33c)
into the trigger cap (33d), and
place over the trigger. Push the
trigger assembly into the gun
housing as shown. Lastly, install
the sliding plastic spring (33b).
11. Double check all wires are laid securely
in the wire channels and the static wick
is in place, then reinstall the gun housing
cover. Ensure housing cover snaps into
place (around trigger components)
before securing with four T15 torx
screws (14) and one T10 torx screw (13).
12. Using same two wrenches, install hose
(22) to needle valve (32).
NOTICE
Failure to ensure wires are away from
pinch points could cause the sprayer to
become inoperable after assembled.
Route the wires exactly as shown below.
To Next Page
Loading...
