3A9322B 15
13. Connect electrical connector.
NOTE: Check to ensure all six pins are
present, fully inserted, and straight inside the
electrical connector on the hose before
connecting. Then push the connectors
together gently, while keeping the
connectors parallel to each other, until they
click together.
14. Install gun cover with cross-head
screws (36). See Assembly Drawing,
page 2, for torques.
15. After assembly is complete, perform
Assembly Verification, page 17.
Solvent Gasket
Removal/Replacement
1. Perform Pressure Relief Procedure,
page 4.
2. Remove battery (24) from sprayer.
3. Remove tip guard (16).
4. Apply pressure while threading solvent
gasket removal tool into the worn gasket
on the gun needle valve (32).
To Next Page
Loading...
