16 3A9322B
5. Once solvent gasket removal tool
bottoms out on the gun face, continue
threading tool into gasket until gasket is
removed from the gun. Worn gasket will
be threaded onto the tool.
6. Use a pliers to remove and discard worn
gasket. Pinch gasket with pliers then
unthread the tool until gasket pops off.
7. Place new solvent gasket (37) onto
opposite side, non-threaded stud of the
solvent gasket installation tool.
8. Assemble tool into the supplied nut.
9. With installation tool, hand tighten the
nut onto front of the gun. Continue to
tighten until the nut has bottomed out.
NOTE: It is recommended to hold the
installation tool below the gun so the gasket
stays centered.
10. Remove nut and tool assembly from
gun. Gasket (37) should be pressed into
the gun needle valve (32).
To Next Page
Loading...
