Graco XM Series Operation Manual

Appendix A
312359J 61
Appendix A
User Interface Display
The user interface display is divided into three main
functions: Setup, Command, and Automatic.
Setup Functions (key “ON”)
The setup functions enable users to:
• set desired mix ratio;
• configure system settings;
• set potlife parameters;
• enable/disable functions, displays, and display
components;
• set which USB logs to download;
• schedule maintenance parameters for alarms
and advisories;
• and set pressure and temperature limits.
NOTE:
All setup functions, except for mix ratio, must be enabled
from the Enable Setup screens before users can change
or set configurations. See Enable Setup Screens, page
66, for instructions.
Command Functions (key “OFF” or removed)
The command functions enable users to:
• run pumps, including flush, circulate, and prime
procedures;
• park pumps so pump rods are down when not in
use;
• mix and spray;
•view mix ratio;
• run pump tests;
• run batch dispense ratio tests;
• run valve leak checks;
• view dispense totals;
• view alarms;
• diagnose alarms;
• and clear alarms.
Automatic Display Functions
The automatic display functions enable users to:
• issue potlife timer alarms
• and download USB logs.

Graco XM Series Specifications

General

Brand	Graco
Model	XM Series
Category	Paint Sprayer
Language	English