Graef HA 800 - Page 26

Operation
26
Example:
START Program P1 P2 P3
Select function
Stacking
Circular
fanning
Long
fanning
Number of slices
10
10 8
Number of
rows/stacks
2
1 3
Press for 2-3
seconds
If programming is done in the sequence P1oP2oP3, the following happens after
switching on the machine:
“Long fanning” function, 3 rows of 8 slices, which is program “P3”.
On changing functions, i.e. by pressing a different button, e.g. Stack, the placing pattern
is set for the corresponding function.
The example above would result in the following stacking pattern: 2 stacks of 10 slices.
It is possible to save the various parameters of a function individually by pressing the
corresponding function button for a long time. However, as already mentioned, the most
recently saved program is always the START program.