Graef HA 800 - Programming a PLU

Operation
35
PLU MENU
new
change
delete
3.7.4 Programming a PLU
Access the program menu by pressing buttons M+PLU.
IMPORTANT!
Always press and hold the “M” button and then press the “PLU” button in addition.
Use the -/+ button to select “PLU”.
Press the M button to confirm.
The following menu appears:
Here you can access the “PLU” menu item, where you can create, change or delete
placing patterns.
Example: “new”
Use the arrow keys to navigate to “new”.
Confirm your selection with the M button.
The following menu appears:
Use the +/- buttons to change the preset value to the desired PLU.
Confirm your selection with the M button.
You can now program the selected PLU:
!
New PLU
PLU: 1