Graef HA 800 - Page 36

Operation
36
Use the +/- buttons to select the individual parameters (mode, X number, slices,
arrangement, ... ).
Pressing the M button then takes you to the editor where you can determine the value
using the +/- buttons.
Pressing the reset button takes you back to the menu for the selected PLU.
PLU 1
Mode Stacking
X number 2
Slices 10
Pattern Lengthwise
Portions 1
X start 0
Y start 10
Dist cross 0
Dist length 100
Strokes / min 50
Thickness 10
Idle time 0