Operation
23
x Use the slicing thickness control to set the
slicing thickness.
The value shown in the display is the slice thickness
in mm.
x Select the placing program and specify the
number of slices with the +/- buttons if
necessary.
x Take hold of the handle of the last slice clamp
and swivel it to the “down” position.
x Push the food to be sliced against the rail and
push the carriage towards the blade.
If the food to be sliced is smaller than 150 mm, use
the last slice clamp.
3.5 HA 810 with Vario-Slice Carriage
The Vario-Slice carriage allows you to slice round products, especially narrow ones, in a
tilted position without a guide rail. The procedure for slicing corresponds to that with the
standard carriage.
To Next Page
Loading...
