Graef HA 800 - Page 38

Operation
38
Strokes / min
(Speed)
Carriage speed in strokes
/min
Only for fully automatic machines
Thickness Indication of desired
thickness. It is indicated on
the display next to the S.
To enable the entry with the +/- buttons without needing
decimals, the value to be entered is factored by 10.
In other words, entering “ 9” is equivalent to a slice thickness
of 0.9 mm.
Idle time Definition of the idle time
between two portions. This
enables the operator to take
goods from the tray without
needing to start the machine
again.
Input is made in steps of 0.5 s.
Maximum idle time: 120 s
Special circular fanning features
Diameter of the circle through
the central points of the slices
(partial diameter)
Note:
The outer diameter of the “DA”
circular fan is the result of the
cutting material calibre DK + Dm
Example:
Salami DK = Ø 60
Set semi-circle Dm = 100
DK 60
Dm + 100
Dm
DA = 160
X start
(X0)
Smallest distance of the y axis to
the slice circle = start position in
X
Y start
(Y0)
Smallest distance of the x axis
to the slice circle = start position
in Y
Dm
Y start
X start
Y
X
DA