General Information
6
x Secure the carriage by inserting paper or cardboard between the thumb guard and
the stop plate.
x Set the slicing thickness below “0” by turning the slicing thickness control to the limit
position.
1.1.1.1 Set-up site requirements
The base must fulfil the following requirements:
x It must be sufficiently stable, strong, level, flat and non-slip.
x It must be of sufficient height to allow slicing while standing.
x It must meet the space requirements listed in “Workspace” (see Technical Data).
x It must be located away from busy corridors.
x It must not be close to any doors.
x It may not be in the swinging area of a door, nor in the entrance area of a door.
x When using Nirosta tables, Resopal supports or similar materials: Ensure that there is
no oil or grease on the surface.
x Ensure sufficient lighting of at least 300 lux
1.1.1.2 Unpacking the machine
Caution!
The machine may only be unpacked and set up by authorised customer service / sales
personnel. Check the required working space (with the machine switched off!):
• Hold the last slice clamp by the handle
• Lift up the last slice clamp
• Move the carriage all the way forward and back
If the carriage or last slice clamp comes into contact with other objects, you must provide
a larger work space.
!
To Next Page
Loading...
