765041776 Rev. 006 11
Fig. 5
Always disconnect the power if interruptions in power supply occur, and when
electrical parts are removed/put on, and before cleaning and maintenance of the
product.
Repairing of electrical/technical parts may only be performed by authorized
technicians with proper knowledge of the product.
Do not use the product before all coverings are installed, so that live or rotating
machine parts cannot be touched.
The product is not to be used outdoor.
All earthing requirements stipulated by the local electricity authorities must be
observed. The plug and wall socket should then give correct earthing. If necessary,
contact an electrician.
Make sure the product is switched off at the socket before service is
performed on electrical parts. It is not sufficient to switch off the product
by the START/STOP key as there will still be voltage to some electrical
To Next Page
Loading...
