Buttons:
The 4 buttons placed on the right side of the display, are used to access and adjust different parameters.
These buttons can be pressed alone or in combination in order to operate the controller.
The below explained settings are the only once which should be changed by the end user. The end user
should not modify any parameters which are not explained here. All other settings should be done by a skilled
technician.
USER SETTINGS
Adjusting the cabinet temperature set-point
• Press and hold Set during normal operation until the display starts flashing, the cabinet
temperature set-point can be adjusted using up and down .
• When the set point has been adjusted to the desired temperature, Set is pressed briefly, in order
to save the new value and to return to normal operation.
How to perform a manual defrost
• Press and hold def for more than 5 sec. during normal operation, in order to perform a manual
defrost, if the evaporator probe temperature is cold enough.
• When the defrost symbol is lit, it does indicate that a defrost is ongoing.
• if def is pressed and held for more than 5 seconds when a defrost cycle is ongoing, the defrost
will be deactivated.
How to mute acoustic alarms
• When the controller is in alarm mode, you will hear an acoustic signal. The alarm can be muted by
pushing Prg/mute .
To Next Page
Loading...
