765042420 Rev.000 10
Fig. 5
Always disconnect the power if interruptions in power supply occur, and when electrical parts are
removed/put on, and before cleaning and maintenance of the product.
Repairing of electrical/technical parts may only be performed by authorized technicians with proper
knowledge of the product.
Do not use the product before all coverings are installed, so that live or rotating machine parts can
not be touched.
The product is not to be used outdoor.
All earthing requirements stipulated by the local electricity authorities must be observed. The plug
and wall socket should then give correct earthing. If necessary, contact an electrician.
Make sure the product is disconnected at the wall socket or at the cabinet inlet
as shown above (Fig. 5), before service is performed on electrical parts. It is
not sufficient to switch off the product by the START/STOP key as there will
still be voltage to some electrical parts of the product.
To Next Page
Loading...
Need help?
General
