Gram Standard Plus - Defrost Water Handling


765042420 Rev.000 20
Defrost water
The product generates defrost water during defrosting, which is conducted out into a re-
evaporation tray at the back of the product (see Fig. 7).
A re-evaporation tube from the cooling system on freezers or an electric heating element placed on
the tray for refrigerators (K and M models) will enable the water to be re-evaporated.
Cleaning the re-evaporation tray at the back of the product is recommended as needed and
at a minimum once annually. Remember to shut off the electrical power to the product
before cleaning.
Be careful not to damage the re-evaporation tube on freezers or the re-evaporation heating
element and associated float switch in refrigerators in connection with any cleaning.
Please note that the re-evaporation components placed on the back of the cabinets can be
hot. This applies both for the pressurised tube on the freezer as well as for the heating element on
the refrigerators. Use proper means of protection (gloves) to avoid burns in connection with
cleaning the re-evaporation trays.
Fig. 7