Gram Standard Plus - Controller Settings and Reset Procedures; Restoring Default Factory Settings; Accessing Service Parameters


765042420 Rev.000 26

Default factor
y
settin
g
s


The controller can be reset to default factory settings. Please be aware that default factory
settings of the controller can differ from the settings implemented when the cabinet was
delivered. Therefore some parameters might have to be modified after resetting to
controller factory setting.
Press buttom
and at the same time for approximately 4 seconds untill the Display shows
"". Then press or untill the display shows “PA“. Press buttom , and the display
will show
„“. Change this value by using or untill the value ”” is shown and then
press and the display will again show “PA“
.
Then press
and at the same time and keep them pressed untill the display shows “dEF“.
Press buttom , and the display will show
„“. Change this value by using or untill
the value
”” is shown and then press .
After this the display shows “dEF“ 4 times and then the default controller settings are restored.
Turn off the power supply to the cabinet and then turn it back on to implement the reset.
The cabinet will start under normal running condition.

Access to service parameters


Press buttons
and at the same time for approximately 4 seconds untill the Display shows
"". Then press or untill the display shows “PA“. Press buttom , and the display
will show
„“. Change this value by using or untill the value ”-” is shown and then
press and the display will again show “PA“
.
Then press
and at the same time and keep them pressed untill the display shows the
first service parameter “SP“.
With the buttons
and it is now possible to select the diffrent service parameters.
Press the button
to access the parameter and then use buttons and to change the
value of the parameter. By pressing the entered value will be saved.
To leave the service parameters press or keep
and pressed for approximately 4
seconds. If no buttons are pressed for 60 seconds the controller automatically leves the service
parameter settings.
Turn off the power supply to the cabinet and then turn it back on to implenet the reset.
The cabinet will start under normal running condition.