765042420 Rev.000 6
If the cabinet has been transported in horizontal position it must stand upright at least 2
hours before it is started to allow the oil from the compressor to run back.
Because of the heavy weight of the product, the floor might be damaged or scratched
when moving the product.
Correct set up gives the most effective operation.
The product should be located in a dry and adequately ventilated room.
To ensure efficient operation, it may not be placed in direct sunlight or against heat-
emitting surfaces. The product is designed to operate in an ambient temperature
between +16C and +40°C.
Avoid placement of the product in a chlorine/acid-containing environment (swimming
bath etc.) due to risk of corrosion.
The product and parts of the interior is equipped with a protecting film, which should be
removed before use.
Clean the product with a mild soap solution before use.
The set up place must be level and horizontal.
For versions with legs, use the adjustable legs to make sure that the product stands
level and upright.
For versions with castors, the locking devices of the two front castors must be activated, when the
product is in place. The base must be level, and the product may not be placed on frames or the
like.
Fig. 2
To Next Page
Loading...
Need help?
General
