26
Follow steps 1 through 5 of the Grill Lighting
Instructions.
Then, push and turn the Infrared Burner Control Knob
to HI/IGN and press the electric ignitor 3 to 4 seconds
to light the burner. Hold the knob in 10 seconds be-
fore releasing. If ignition does not occur follow step 7
before retrying.
After the Infrared Burner is lit it will reach cooking
temperature quickly. The orange/red glow will even
out within minutes.
USE AND CARE INSTRUCTIONS
Grill Lighting Instructions
Before each use, check all hoses for cracks, nicks, cuts,
burns or abrasions. If a hose is damaged in any way, do
not use your grill before replacing the hose with an
authorized part from the Parts List. Also make sure all
gas supply connections are securely tightened.
Familiarize yourself with the safety and Use and Care
instructions in this manual. Do not smoke while lighting
grill or checking gas supply connections.
Be sure the LP Gas tank is filled.
Open the Grill Lid before lighting.
4.
3.
2.
1.
Rotisserie Burner Lighting Instructions
Follow steps 1 through 5 of the Grill Lighting
Instructions.
Then, push and turn the Rotisserie Burner Control
Knob to HI/IGN and press the electric ignitor 3 to 4
seconds to light the Burner. Hold the knob in 10
seconds before releasing. If ignition does not occur
follow step 7 before retrying.
1.
3.
2.
After the Rotisserie Burner is lit it will reach
cooking temperature quickly. The orange/red glow
will even out within minutes.
Burner Control Knobs on Control Panel
Set Control Knobs to OFF and open the LP Gas
SLOWLY 1/4 of a turn.
Push and turn the RIGHT Main Burner Control Knob
to HI/IGN. Always light the RIGHT Main Burner first.
Press the electric ignitor 3 to 4 seconds to light the
burner.
If ignition does not occur in 5 seconds, turn the
Burner Control(s) off, wait 5 minutes, and repeat the
lighting procedure. If ignition still does not occur,
turn the burner control(s) and gas source OFF. Wait
5 minutes for gas to clear and then conduct a leak
test of ALL gas connections and gas sources as
explained in the Use and Care section of this
manual. If no leaks are detected, wait 5 minutes for
any gas to clear and repeat the lighting procedure.
After one Burner is lit, turn the tank valve SLOWLY
one more 1/4 of a turn.
Repeat steps to light each burner individually.
9.
8.
7.
Infrared Burner Lighting Instructions
1.
3.
2.
Follow steps 1 through 5 of the Grill Lighting
Instructions.
Open Range Lid before lighting.
Push and turn the Control Knob to HI/IGN and press
the electronic ignitor 3 to 4 seconds to light the Burner.
If ignition does not occur, turn the Burner Control off,
wait 5 minutes, and repeat the lighting procedure. If
ignition still does not occur, turn the burner control(s)
and gas source OFF. Wait 5 minutes for gas to clear
and then conduct a leak test of ALL gas connections
and gas sources as explained in the Use and Care
section of this manual. If no leaks are detected, wait 5
minutes for any gas to clear and repeat the lighting
procedure.
1.
Side Burner or Griddle Lighting Instructions
2.
3.
4.
IMPORTANT: Do not use the Back Burner and Main
Burners at the same time.
Grill
Range
Side Burner Griddle Burner
OFF
OFF
OFF
LOW
Failure to replace a faulty hose, secure gas supply
connections or to open the Lid before proceeding
to the Lighting Procedures could result in a fire
or explosion that could cause serious bodily injury,
death, or property damage.
WARNING
! !
5.
tank valve
Open LP
gas tank
OFF
HI/IGN
HI/IGN
HI/IGN
6.
Main Burner Rotisserie Burner Infrared Burner
To Next Page
Loading...
