Configure Uprgade via Choose the protocol that will be used for upgrading.
Configure Server Path Defines the server path for provisioning.
Configure Sever Username The username for the config server.
Configure Sever Password The password for the config server.
Always Indicate before Challenge
If enabled, the phone will send credentials before being challenged by the server. This option only
applies to HTTP/HTTPS.
Config File Prefix
If configured, only the configuration file with the matching encrypted prefix will be downloaded
and flashed into the phone.
Config File Postfix
If configured, only the configuration file with the matching encrypted postfix will be downloaded
and flashed into the phone.
Authenticate Conf File If enabled, the phone will authenticate configuration file before acceptance.
XML Config File Password
Configures the password for encrypting the XML configuration file using OpenSSL. This is
required for the phone to decrypt the encrypted XML configuration file.
Parameter Description
Auto Upgrade
Automatic Upgrade Enables automatic upgrade and provisioning.
Start Upgrading at Random
Time
Configures whether the phone will upgrade automatically at a random time within the configured time
interval.
Firmware Upgrade and
Provisioning
Specifies how firmware upgrading and provisioning request to be sent.
DHCP Option
Allow DHCP Option 43 and
Option 66 to Override Server
If set to "Yes" on the LAN side, the phone will reset the CPE, upgrade, network VLAN tag and
priority configuration according to option 43 sent by the server. At the same time, the upgrade mode
and server path of the configuration mode will be reset according to option 66 sent by the server. If set
to "prefer, fallback when failed", the phone can fallback to use the configured provisioning server
under its Firmware and Config server path in case the server from DHCP Option fails.
Allow DHCP Option 120 to
Override SIP Server
Specifies the name of the client. This field is optional but may be required by Internet Service
Provider.
Additional Override DHCP
Option
Configures additional DHCP Option to be used for firmware server instead of the configured firmware
server or the server from DHCP Option 33 and 66.
This option will be effective only when "Allow DHCP Option 43 and Option 66 to Override Server" is
enabled.
Config Provision
Download and Process All
Available Config Files
By default, the device will follow cfgMAC.xml, cfgMAC, cfgMODEL.xml, cfg.xml, devMAC.cfg
sequence searches for the first available configuration file and updates the configuration file, and the
subsequent configuration files will be ignored.If this configuration item is enabled, the device will
To Next Page
Loading...
Need help?
General
