2. User needs to set up a TFTP server, set the address to 192.168.0.2, and store two files under the server address,
ghp610recovery.bin, and ghp610fw.bin. Please download these two files from the official website.
3. During the startup phase of U-boot, some recoverable partition files will be verified. If the verification of partition files fails,
the MWI LED will flash yellow for 3 seconds to enter the recovery process.
4. At this time, the device IP will be automatically set to 192.168.0.3, and a TFTP request will be sent to the fixed server
192.168.0.2, requesting the file ghp610recovery.bin.
– If there is no server, it will still request, and the yellow light stays always on.
– If the request fails, the yellow light is off, the MWI LED red light flashes for 3 seconds, and the Linux system is blocked and
cannot be recovered.
– If the request is successful and the loading operation continues, the yellow light goes out, the MWI LED green light flashes
for 3 seconds and the temporary Linux system starts to boot.
5. When the temporary Linux system starts up, the MWI light is always yellow. The system sets the IP address as fixed
192.168.0.3, and sends a TFTP request to the fixed server 192.168.0.2, requesting the file ghp610fw.bin for upgrading. The
upgrade process takes about 5 minutes, during which the MWI LED flashes red.
6. After the upgrade is completed, the device automatically restarts and returns to normal. If the upgrade fails, the MWI LED
will stay red.
CHANGELOG
Firmware 1.0.1.37
Added Support of Redial Expiration. [REDIAL EXPIRATION]
Added Support of PNP Service. [PNP SERVICE]
Added Support of keeping alive to NAT Traversal [NAT TRAVERSAL]
Added Support for local call features. [LOCAL CALL FEATURES]
Firmware 1.0.1.33
Added Support of “Enable Basic Settings in IVR” configuration [ENABLE BASIC SETTINGS IN IVR]
Added Support for NAT Traversal. [NAT TRAVERSAL]
Added Support for STUN server. [STUN SERVER]
Firmware 1.0.1.29
This is the initial release.
COPYRIGHT
©2023 Grandstream Networks, Inc. https://www.grandstream.com
All rights reserved. Information in this document is subject to change without notice. Reproduction or
transmittal of the entire or any part, in any form or by any means, electronic or print, for any purpose without the express
written permission of Grandstream Networks, Inc. is not permitted.
Grandstream is a registered trademark and the Grandstream logo is the trademark of Grandstream Networks, Inc. in the
United States, Europe, and other countries.
CAUTION
To Next Page
Loading...
Need help?
General
