P a g e | 62
GXW42xx User Manual
Version 1.0.15.30
Default is Yes, and active star code is 02.
For enabling each codec feature, default is Yes.
Forced codec code (02 in default case) is followed by Codec code.
Default code of codec:
PCMU – 7110
PCMA – 7111
G723 – 723
G729 – 729
AAL2-G728-R16 – 72616
AAL2-G728-R24 – 72624
AAL2-G728-R32 – 72632
AAL2-G728-R40 – 72640
iLBC – 7201
G722 – 722
Custom Ring Tone 1 to 3 with associate Caller ID: when selected, if Caller ID is
configured, then the device will ONLY uses this ring tone when the incoming call is
from the Caller ID. System Ring Tone is used for all other calls. When selected but
no Caller ID is configured, the selected ring tone will be used for all incoming calls.
Distinctive ring tones can be configured not only for matching whole number, but also
for matching prefixes. In this case symbol * (star) will be used. If server supports Alert-
Info header and standard ring tone set (Bellcore) or distinctive ring tone 1-10 is
specified, then the ring tone in the Alert-Info header from server will be used.
For example:
If configured as *617, Ring Tone 1 will be used in case of call arrived from
Massachusetts. Any other incoming call will ring using cadence defined in parameter
System Ring Cadence located under Advanced Settings Configuration page.
Configure ring cadences according to preference.
Table 11: FXS Ports
User account information, provided by VoIP service provider (ITSP). Usually in the form
of digit similar to phone number or actually a phone number.
SIP service subscriber’s Authenticate ID used for authentication. Can be identical to
or different from SIP User ID.
To Next Page
Loading...
Need help?
General
