FIRMWARE 1.0.4.4 GXW42XX USER MANUAL PAGE 30 OF 57
CONFIGURATION GUIDE
CONFIGURING GXW42XX VIA VOICE PROMPT
DHCP MODE
Select voice menu option 001 to enable GXW42XX to use DHCP.
STATIC IP MODE
Select voice menu option 001 to enable GXW42XX to use STATIC IP mode, then use option 002, 003,
004, 005 to set up IP address, Subnet Mask, Gateway and DNS server respectively.
PPPOE MODE
Select voice menu option 001 to enable GXW42XX to use PPPoE mode.
FIRMWARE SERVER IP ADDRESS
Select voice menu option 013 to configure the IP address of the firmware server.
CONFIGURATION SERVER IP ADDRESS
Select voice menu option 014 to configure the IP address of the configuration server.
UPGRADE PROTOCOL
Select voice menu option 015 to choose firmware and configuration upgrade protocol. User can choose
between TFTP, HTTP, and HTTPS.
FIRMWARE UPGRADE MODE
Select voice menu option 017 to choose firmware upgrade mode among the following three options:
1) always check, 2) check when pre/suffix changes, and 3) never upgrade
CONFIGURING GXW42XX WITH WEB BROWSER
The GXW42XX series gateway has an embedded Web server that allows users to configure the
GXW42XX through a web browser. It has language support to English, Chinese, French, and Spanish.
To Next Page
Loading...
Need help?
General
