FIRMWARE 1.0.4.4 GXW42XX USER MANUAL PAGE 40 OF 57
Using these settings, user can configure tone frequencies according to user preference. By
default, the tones are set to North American frequencies. Frequencies should be configured
with known values to avoid uncomfortable high pitch sounds. ONis the period of ringing (ON
time in ms) while OFF is the period of silence. In order to set a continuous ring, OFF should be
zero. Otherwise it will ring ON ms and a pause of OFF ms and then repeat the pattern.
• “Dial tone”
• “Ringback tone”
• “Busy tone”
• “Reorder tone”
• “Confirmation tone”
• “Call-Waiting tone”
Please refer the document below to determine your local call progress tones:
http://www.itu.int/ITU-T/inr/forms/files/tones-0203.pdf
Enable or disable the Failover FXO Gateway.
IP Address or URI of the FXO gateway.
Disables the Direct IP Call function. Default is “No”. If set to “Yes” direct IP-to-IP calling will
not be supported.
Disable SIP
NOTIFY
Authentication
Disables challenging SIP NOTIFY reboot and resync messages.
Disables the voice prompt configuration. Default is “No”. If set to “Yes” accessing integrated
voice menu will be impossible.
Choose English, Chinese, or Spanish.
Choose language for LCD display.
Simulates an analog PBX where a code is required to dial an outside line.
TABLE 10: PROFILES
To Next Page
Loading...
