EasyManua.ls Logo

Grandstream Networks GXW42XX series - SIP Settings - Security Settings; Fax Settings

Grandstream Networks GXW42XX series
57 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
FIRMWARE 1.0.4.4 GXW42XX USER MANUAL PAGE 44 OF 57
Caller Request
Timer
If selecting “Yes” the phone will use session timer when it makes outbound calls if remote party
supports session timer.
Callee Request
Timer
If selecting “Yes” the phone will use session timer when it receives inbound calls with session
timer request.
Force Timer
If selecting “Yes” the phone will use session timer even if the remote party does not support this
feature. Selecting “No” will allow the phone to enable session timer only when the remote party
support this feature.
To turn off Session Timer, select “No” for Caller Request Timer, Callee Request Timer, and
Force Timer.
UAC Specify
Refresher
As a Caller, select UAC to use the phone as the refresher, or UAS to use the Callee or proxy
server as the refresher.
UAS Specify
Refresher
As a Callee, select UAC to use caller or proxy server as the refresher, or UAS to use the phone
as the refresher.
Force INVITE
Session Timer can be refreshed using INVITE method or UPDATE method. Select “Yes” to use
INVITE method to refresh the session timer.
SIP Settings - Security Settings
Validate Incoming
Messages
Defines whether the incoming messages will be validated.
Check SIP User ID
for Incoming
INVITE
If set to "Yes", SIP User ID will be checked in the Request URI of the incoming INVITE. If it
doesn't match the phone's SIP User ID, the call will be rejected. Direct IP calling will also be
disabled.
Accept Incoming
SIP from Proxy
Only
If set to "Yes", SIP User ID will be checked in the Request URI of the incoming INVITE. If it
doesn't match the phone's SIP User ID, the call will be rejected. Direct IP calling will also be
disabled.
Authenticate
Incoming INVITE
If set to "Yes", the phone will challenge the incoming INVITE for authentication with SIP 401
Unauthorized response.
Fax Settings
Fax Mode
T.38 (Auto Detect) FoIP by default, or Pass-Through (must use codec PCMU/PCMA)
Fax Tone
Detection Mode
Default is Callee. This decides whether Caller or Callee sends out the re-INVITE for T.38 or
Fax Pass Through.

Table of Contents

Related product manuals