Grandstream Networks HT502 User Manual

P a g e | 21
HT502 User Manual
 iLBC
 G-726
 G-723
 G-729
10
“MAC Address”
Announces the Mac address of the unit.
12
WAN Port Web Access
Press “9” to toggle between enable / disable
13
Firmware Server IP
Address
Announces current Firmware Server IP address. Enter 12
digit new IP address.
14
Configuration Server IP
Address
Announces current Config Server Path IP address. Enter 12
digit new IP address.
15
Upgrade Protocol
Upgrade protocol for firmware and configuration update. Press
“9” to toggle between TFTP / HTTP / HTTPS
16
Firmware Version
Firmware version information.
17
Firmware Upgrade
Firmware upgrade mode. Press “9” to toggle among the
following three options:
- always check
- check when pre/suffix changes
- never upgrade
47
“Direct IP Calling”
Enter the target IP address to make a direct IP call, after dial
tone. (See “Make a Direct IP Call”.)
70
Phone calls between FXS
1 and FXS 2 port
User can make internal calls between two FXS ports on the
same HT502 even without being registered to SIP server. By
dialing *** and 70, user can reach the other FXS port
86
Voice Mail
Number of Voice Mails

Grandstream Networks HT502 Specifications

General

Brand	Grandstream Networks
Model	HT502
Category	Telephone Accessories
Language	English