Default is No. If set to YES Call Waiting indication information will not be
provided to analog phone connected to this FXS port.
Disable Call-Waiting
Caller ID
Default is No. If set to YES Call Waiting caller ID will not be provided to analog
phone connected to this FXS port.
Disable Call Waiting
Tone
Default is No. This is to disable the stutter Call Waiting Tone when a Call Waiting
information arrives. The CWCID information will still be displayed.
Disable Connected
Line ID
Default is No. If set to Yes, Connected Line ID will not be displayed even if
received.
Disable Reminder
Ring for On-Hold Call
Default is No. Do not play the reminder ring when this is set to Yes.
If set to “Yes”, the MWI information will not be transferred to the analog phone
connected to the FXS port.
Do Not Escape '#'
as %23 in SIP URI
If set to “Yes”, device will use ‘#’ instead of %23 in the send URI.
Disable Multiple m
line in SDP
Default is No. If set to Yes, device will send only one m line in SDP, regardless
how many m field in the incoming SDP.
Incoming call will stop ringing when not picked up given a specific period of time.
Delayed Call Forward
Wait Time
Default value is 20 seconds. In case this feature activated using * codes (*92
code), the call will be forwarded after this preconfigured amount of time.
Default is 4 seconds. Dialing process is completed and outgoing call is initiated
if no key entry occurs during this preconfigured interval.
Default is No. Use only if proxy supports 484 response. This parameter
controls whether the phone will send an early INVITE each time a key is pressed
when a user dials a number. If set to “Yes”, an INVITE is sent using the dial-
number collected thus far; Otherwise, no INVITE is sent until the “(Re-)Dial”
button is pressed or after about 5 seconds have elapsed if the user forgets to
press the “Re-Dial” button.
To Next Page
Loading...
Need help?
General
