Grandstream Networks HT814 User Manual

P a g e | 20
HT812/HT814 User Guide
Version 1.0.15.4
04
“Gateway “ + IP address
Same as menu 02
05
“DNS Server “ + IP
address
Same as menu 02
07
Preferred Vocoder
Press “9” to move to the next selection in the list:
• PCM U / PCM A
• iLBC
• G-726
• G-723
• G-729
• OPUS
• G-722
10
“MAC Address”
Announces the MAC address of the unit.
Note: The device has two MAC addresses. One for the WAN port and
one for the LAN port. The device MAC address announced is the
address of LAN port.
12
WAN Port Web Access
Press “9” to toggle between enable/disable.
Default is disabled.
13
Firmware Server IP
Address
Announces current Firmware Server IP address. Enter 12-digit new
IP address.
14
Configuration Server IP
Address
Announces current Config Server Path IP address. Enter 12-digit
new IP address.
15
Upgrade Protocol
Upgrade protocol for firmware and configuration update. Press “9” to
toggle between TFTP / HTTP / HTTPS/ FTP/FTPS. Default is HTTPS.
16
Firmware Version
Announces Firmware version information.
17
Firmware Upgrade
Firmware upgrade mode. Press “9” to toggle among the following three
options:
• Always check
• Check when pre/suffix changes
• Never upgrade
47
“Direct IP Calling”
Enter the target IP address to make a direct IP call, after dial tone. (See
“Make a Direct IP Call”.)
86
Voice Mail
Access to your voice mails messages.
99
“RESET”
Press “9” to reboot the device.
Enter MAC address to restore factory default setting
(See Restore Factory Default Setting section)
“Invalid Entry”
Automatically returns to main menu
“Device not registered”
This prompt will be played immediately after off hook If the device is
not register and the option Outgoing Call without Registration is in NO

Grandstream Networks HT814 Specifications

General

Brand	Grandstream Networks
Model	HT814
Category	Telephone Accessories
Language	English