After applying your configuration, your account will register to your SIP Server, you can verify if it has been
correctly registered with your SIP server from your HT812/HT814 web interface under Status → Port
Status → Registration (If it displays Registered, it means that your account is fully registered, otherwise
it will display Not Registered so in this case you must double check the settings or contact your provider).
Figure 13: Accounts Status
Note: When all the FXS ports are registered, the simultaneous ring will have one second delay between
each ring on each phone.
Rebooting HT812/HT814 from Remote
Press the “Reboot” button at the bottom of the configuration menu to reboot the ATA remotely. The web
browser will then display a message window to confirm that reboot is underway. Wait 30 seconds to log in
again.
To Next Page
Loading...
Need help?
General
