2. Open the web browser on your computer.
3. Enter the HT812/HT814’s IP address in the address bar of the browser.
4. Enter the administrator’s password to access the Web Configuration Menu.
Note: The computer must be connected to the same sub-network as the HT812/HT814. This can be easily
done by connecting the computer to the same hub or switch as the HT812/HT814.
- Via LAN port
Please refer to steps below if your HT812/HT814 is connected via LAN port:
1. Power your HT812/HT814 using PSU with the right specifications.
2. Connect your computer or switch directly to your HT812/HT814 LAN port.
3. Open the web browser on your computer.
4. Enter the default LAN IP address (192.168.2.1) in the address bar of the browser.
5. Enter the administrator’s password to access the Web Configuration Menu.
6. Make sure to reboot your device after changing your settings to apply the new configuration.
Note: Please make sure that your computer has a valid IP address on the range 192.168.2.x so you can
access the web GUI of your HT812/HT814.
Web UI Access Level Management
There are two default passwords for the login page:
The password is case sensitive with maximum length of 25 characters.
When changing any settings, always submit them by pressing Update or Apply button on the bottom of
the page. After submitting the changes in all the Web GUI pages, if a reboot is required, the web page will
prompt the user to reboot by offering a reboot button on the web page.
Saving the Configuration Changes
After users make changes to the configuration, pressing Update button will save but not apply the changes
until Apply button is clicked. Users can instead directly press Apply button. When a reboot is required to
apply changes, the web page will prompt the user to reboot by offering a reboot button on the web page.
To Next Page
Loading...
Need help?
General
