32
Flue Lining Kits
Grant EZ-Fit Flexi Pack conventional flue
system (Orange System)
A range of Flexi pack conventional
flue lining kits are available from Grant
UK. The packs have been specifically
produced for Grant VORTEX oil fired
condensing boilers.
The pack includes a terminal/top plate/flexi
flue adaptor, stainless steel smooth bore
flexible flue liner, a rigid to flexi adaptor
and a boiler flue connector.
Two diameters are available, a 100 mm
for models up to 46 kW and 125 mm for
models above 46 kW.
Extensions
A range of white powder coated single
wall extensions are available to connect
the boiler to the flexible liner.
The nominal diameter of the extensions
is 100 mm or 125 mm.
Extensions are supplied with locking
bands.
Flue System and
Air Supply
Flue extensions cannot be cut.
Also available are:
• An adjustable extension
• 45° elbow
The rigid flue between the boiler and
flexible flue liner should incorporate an
adjustable section to allow inspection
and cleaning of the flue system.
NOTE
!
Figure 9-3: Grant Orange flue system in a typical brick chimney
Part No.
GFKIT 6/100
GFKIT 6/125
GFKIT 8/100
GFKIT 8/125
GFKIT 10/100
GFKIT 10/125
GFKIT 11/100
GFKIT 11/125
GFKIT 12/100
GFKIT 12/125
GFKIT 14/100
GFKIT 14/125
GFKIT 16/100
GFKIT 16/125
Flexi Pack (Orange System)
100mm dia. x 6 metre
125mm dia. x 6 metre
100mm dia. x 8 metre
125mm dia. x 8 metre
100mm dia. x 10 metre
125mm dia. x 10 metre
100mm dia. x 11 metre
125mm dia. x 11 metre
100mm dia. x 12 metre
125mm dia. x 12 metre
100mm dia. x 14 metre
125mm dia. x 14 metre
100mm dia. x 16 metre
125mm dia. x 16 metre
Part No.
WX 150/100
WX 150/125
WX 250/100
WX 250/125
WX 450/100
WX 450/125
WX 950/100
WX 950/125
Extensions (Orange System)
100mm dia. x 150mm
125mm dia. x 150mm
100mm dia. x 250mm
125mm dia. x 250mm
100mm dia. x 450mm
125mm dia. x 450mm
100mm dia. x 950mm
125mm dia. x 950mm
Brick
chimney
Flaunching
Locking band
Rigid to flexible flue
connector (bottom)
This
component
must be installed
vertically
Note:
Extension
Boiler flue
connector
Boiler
Flexible stainless
steel liner
The flue liner
is directional
(see Section 9.2)
Note:
Terminal
Adjustable section 235/300mm
WXA250/100
WXA250/125
100mm dia.
125mm dia.
Locking band
C
45 elbow
O
Top plate
Clamp