19
13. Be careful with the cables to safety switch if steam reduction is
installed.
14. Undo the lower wheels.
15. Undo the wheel brackets and wheels from the lift yoke.
Assembling:
16. Put the upper brackets and wheels back (replace if necessary)
into place.
17. Put (if needed, replace) the lower wheels back.
18. Fasten the screws for the brackets without tightening them.
19. Fasten the screws between the brackets and the hood.
20. Put the brackets in the same position as before. (see point 10)
and tighten the screws. Put back the screws back that fasten
To Next Page
Loading...
