11
12. For thin paper you may need to use 1 or 2 magnetic deflectors to stop the paper from lifting.
13. Programming a Crease Job:
• Turn on machine. Screen 1 will appear after the welcome page
Screen 1 Screen 2
• Press M button once, the screen will change to Screen 2 and line [1] will flash.
• Enter line [1] value, 3 (3.0). Press ENTER, line [2] will flash.
• Enter line [2] value, 6 (6.0). Press ENTER, screen change to Screen 3, line [3] will flash.
Screen 3 Screen 4
• Enter line [3] value 9 (9.0). Press Enter, line [4] will flash.
• Press ENTER when line [4] is 0, screen will change to Screen 4.
• Press RUN to feed a sheet. Paper is creased at 3", 6", 9" (crease line distance from the leading edge).
• Press STOP if you want to stop the job.
To Next Page
Loading...