26
Install the blades on the tool mount shaft as shown below:
Screw 1 fixes the tool onto the machine.
Screw 2 adjusts the tool depth of the tool, i.e. crease depth, perforate depth, kiss cutter depth,
etc. This screw is important to the kiss cutter adjustment.
Mount the anvil on the outfeed shaft after it is uninstalled from the machine.
Removing Roller:
1. Remove the clip at the operator side of the roller.
2. Grab the shaft, slide right to loosen it, and remove it from the machine.
3. Loosen the set screw of anvils and install the new anvils in order. Mind the flat part of the shaft,
all set screws should touch this flat surface.
To Next Page
Loading...