GRAPHTEC CE LITE-50 - Cutting Printed Media with Software

3-11
Chapter 3 Cutting along Printed Data
[4] Cutting the printed media
Media Transport Direction
X
Y
Registration Mark Type 1 Registration Mark Type 2
1. Load the printed media onto CE LITE-50.
5HIHUWR/RDGLQJ6KHHW0HGLD
2. Click the "Cut Contour" icon.
3. The "Cut Contour" screen will launch.
In order to match the orientation in
ZKLFKWKHPHGLDKDVEHHQORDGHGVHW
527$7(WR
".

:KHQWKHCut Contour" screen is
GLVSOD\HGIRUWKHÀUVWWLPHWKH$GG
'HYLFHVFUHHQZLOOEHGLVSOD\HG
)ROORZWKHRQVFUHHQLQVWUXFWLRQVWR
select "CE LITE-50" for the model
QDPHDQG*UDSKWHF86%IRUWKH
connection destination.
4. &OLFNWKH6HQG
Move tool
here
Media Transport Direction
X
Y
Registration Mark Type 1 Registration Mark Type 2
5. $FRQÀUPDWLRQVFUHHQZLOODSSHDU
0RYHWKHWRROWRWKHUHJLVWUDWLRQPDUNUHGVTXDUHDWWKHWRS
OHIWDQGFOLFNWKH2.
6FDQQLQJRIWKHUHJLVWUDWLRQPDUNVZLOOEHJLQDQGRQFHDOO
RIWKHUHJLVWUDWLRQPDUNVKDYHEHHQVFDQQHGWKHFXWWLQJZLOO
EHJLQ