Need help?Do you have a question about the GRAPHTEC CE2000-60 and is the answer not in the manual?
General| Model | CE2000-60 |
|---|---|
| Category | Plotter |
| Max Cutting Width | 603 mm |
| Cutting Area | 603 mm x 50 m |
| Max Media Width | 712 mm |
| Command Sets | HP-GL, GP-GL |
| Power Supply | AC 100-240V, 50/60Hz |
| Programmable Resolution | 0.025 mm |
| Media Thickness | Up to 0.25 mm (depending on the media) |
| Blade Type | Supersteel |
| Interface | RS-232C |
| Operating Environment | Temperature: 10-35°C, Humidity: 35-75% (non-condensing) |
Covers operational safety, electrical safety, and environmental concerns.
Provides step-by-step instructions for assembling the CE2000-120 model.
Explains the function of each key and lamp on the control panel.
Details how to connect the plotter to a computer via interface cable.
Step-by-step guide on powering on the cutting plotter.
Instructions for loading roll media and single sheets.
Guides on setting command mode, step size, origin point, and interface conditions.
Detailed steps for replacing the cutter blade and adjusting its length.
Explains how to set blade type, force, speed, quality, and offset.
Procedure for performing a cutting test to verify settings.
Procedure for printing a test pattern to check plotter precision.
Troubleshooting steps if the plotter does not turn on or display.
Explains causes and solutions for mechanical errors like CURRENT LIMIT.
Lists command errors and their causes/solutions in GP-GL and HP-GL modes.
Troubleshooting common problems with cutting quality.
To Next Page