GRAPHTEC CE2000-60 - Specifying Pen Up Speed

7 – 2
7.1 Specifying the PEN UP SPEED
This function is used to specify the travelling speed of the cutter pen in raised status. It can be specified
independently of the cutting SPEED function. When the PEN UP SPEED is high, the cutter pen travels
faster while in raised status to shorten the overall cutting time. Your cutting plotter comes with its PEN
UP SPEED set to AUTO, which selects the same speed as the cutting SPEED function (the cutter
pen is in lowered status). Note that if you perform long-axis cutting of film with a high PEN UP SPEED
setting, the film is likely to become jammed.
Step 1
Press the
PAUSE
key to enter PAUSE mode.
Step 2
Press the
NEXT PAGE
key until the menu below appears.
INTERFACE
PEN UP/DOWN
Step 3
Simultaneously press the
ENTER
and
NEXT PAGE
keys to display the menu below.
PEN UP SPEED
OFFSET FORCE
Step 4
Press the
F1/ORIGIN
key (PEN UP SPEED) to display the menu below.
PEN UP SPEED
AUTO
Use the and keys to select the desired PEN UP SPEED and then press the
ENTER
key to
register your setting.
The PEN UP SPEED can be set to AUTO (the PEN UP SPEED setting becomes identical to the SPEED
setting) or to 10, 20, 30, or 60 cm/s.
Step 5
Press the
PAUSE
key to cancel the PAUSE mode.
NOTE : The PEN UP SPEED setting is retained in the cutting plotter’s internal memory, even
while the cutting plotter is turned off.